2021 Ford Super Duty F-600 DRW XL 2WD Reg Cab 169" WB 84" CA

$0.00
$0.00
$0.00
$0.00
$0.00
$0.00
$0.00
$0.00
$100.00
$0.00
Read more
(STD)
$10,075.00
Read more
transmission mounted live drive and stationary mode PTO, 27 litre (7.2 gallon) plastic urea tank, exhaust brake, B20 capability, urea gauge and intelligent oil life monitor, 397 Amp Alternators, Rapid-Heat Supplemental Cab Heater, Dual 78-AH 750 CCA Batteries
$0.00
Read more
10R140 w/neutral idle, SelectShift and selectable drive modes: normal, tow/haul, eco, deep sand/snow and slippery
$0.00
Read more
Spare may not be the same as the road tire
$320.00
Read more
Spare may not be the same as the road tire
$300.00
Read more
Spare may not be the same as the road tire, 4 traction tires on the rear and 2 A/P tires on the front
$0.00
Read more
integrated armrest w/2 cupholders and driver manual lumbar
$260.00
Read more
integrated armrest w/2 cupholders and driver manual lumbar
$390.00
Read more
driver manual lumbar
$650.00
Read more
driver manual lumbar

Selecting an option here is not required

$220.00
Read more
Chrome Front Bumper
$500.00
Read more
XL Decor Package, Chrome Front Bumper, Cruise Control
$0.00
$300.00
$400.00
Read more
hardened engine intake valves and valve seats, Note: This package does not include CNG/propane fuel tanks, lines, etc, Vehicle will be equipped w/the standard factory gasoline fuel system, Additional equipment combined w/certified calibration reflash is required, from an external upfitter, to convert the vehicle to a CNG/propane fueled vehicle, Ford Motor Company does not provide an exhaust or evaporative emissions certificate w/this option when converted to use CNG or propane fuel, Ford does not represent that a vehicle converted to use CNG or propane will comply w/all applicable U.S, or Canadian safety standards, It is the responsibility of the final stage manufacturer (body builder, installer, alterer or subsequent stage manufacturer) to determine that any vehicle converted to use CNG or propane complies w/U.S, federal, California, or Canadian exhaust and evaporative emission requirements, Federal fuel economy standards, U.S, and Canadian safety standards,
$200.00
$200.00
$200.00
$200.00
$350.00
Read more
smart trailer tow connector, Verified to be compatible w/electronic actuated drum brakes only
$160.00
Read more
pre-selected springs (see Super Duty Supplemental Reference Manual for springs/GAWR of specific vehicle configurations), Note 1: Restrictions apply; see Super Duty Supplemental Reference Manual or Body Builders Layout Book for details, Note 2: Also allows for the attachment of a winch, Note 3: Upgraded front springs will result in stiffer ride when a snow plow is not installed
$100.00
Read more
2-inch spacer blocks, Recommended for rear-biased loading, such as wrecker/retriever applications
$-75.00
$890.00
Read more
Combines 151 litre aft-of-axle tank, 100 litre mid-ship tank and dual fuel fill on driver's side
$410.00
Read more
Excludes carrier, 6-Ton Hydraulic Jack
$150.00
$490.00
$0.00
Read more
Standard in British Columbia, Manitoba, New Brunswick, Ontario and Saskatchewan
$220.00
$800.00
Read more
Custom accessory, 2 lights mounted on the centre high-mounted stop light bar and 2 hood mounted lights
$800.00
Read more
Custom accessory, pre-installed, alternating amber/white flash pattern
$40.00
$225.00
$350.00
$290.00
$290.00
$400.00
Read more
Automatic Emergency Braking (AEB), automatic high beams and forward collision warning
$150.00
$550.00
Read more
loose camera and wiring bundle
$400.00
Read more
the UIM pre-installed and interface cables (2- 3' blunt cut cables w/connectors), Note: The Upfitter Interface Module (UIM) is an electronic control module that provides output signals for aftermarket equipment (such as lift buckets, cranes, motors, salt spreaders, snow plows, etc.) via customer programmable logic based on switch inputs and vehicle CAN bus messages, The operation of such equipment is limited to the load parameters of the UIM, The UIM does not come pre-programmed for use, It must be configured by the upfitter for aftermarket equipment, The UIM provides output signals only, and is not intended to directly power any aftermarket device, Customer must use external relays to drive any equipment, Ford Motor Company is not responsible for debugging or verifying the function of the customer created UIM program files, It is the responsibility of the upfitter to ensure proper function of the software created to complete their upfit
$250.00
Total

$57,609.00

Related Trims: